swift car parts 37 views   3 clicks ♡

Left hand and right hand are different can not swap over.

Photo shows one handle with a sensor in it.that is there to show the color only.email what color you need

No overseas sales

NO OVERSEAS SALES

Brakes Rear

Brakes Rear

NO OVERSEAS SALESDimensions.Dia 231MM60mm Centre4 Stud.PCD. 100MMMin Thickness 17MM.

Engine

Always wear Protective Equipmemt when working on BrakesWhen fitting new brake pads an inspection should be carried out on the condition of the brake rotors, especially ifthe brake pads have worn down to the metal.Any grooves or ridges on the rotor and they should be machined to give a smooth and eve...

Normally New Zealand new only vehicles run this brake rotorNOTE.Specs:Diameter 272mm.Height 40mm.Thickness 20mm.Center Hole 60mm.RDA 1818 Pads4 Stud.There is some that run the 252mm as well you may need to measure dia disc

NO OVERSEAS SALESDimensions.Dia 252.00 mm.60mm Centre4 Stud.PCD. 100.00 mm.Min Thickness 15.00 mm.

Very good stopping powerNo overseas sales

Normally New Zealand new only vehicles run this brake rotorNOTE.Specs:Diameter 272mm.Height 40mm.Thickness 20mm.Center Hole 60mm.4 Stud.There is some that run the 252mm as well you may need to measure dia disc

Accessories

This is the 252mm dia brake disc.Some do run 272mm dia brake disc but is rare.Really need the dia to send correct rotors.

Brakes Rear

Accessories

NB.This is for Disc Braking rear system.

SPECS:Diameter 252mm.Height 40mm.Thickness min. 18mmThickness New 20mmCenter Hole 60mm.4 stud

Brakes Rear

No overseas sales.

TIPS;Ignitions coils break down,but so do the plug leads.through heat variation,age ,oil contamination.If you see oil on the bottom of your plug leads it means the rocker cover gasket has gone hard with age andallows oil to seep through onto the plugs and leads creating problems like engine miss los...

id.THIS ONE IS SILVER LABELPART No 3R or 3J12V-80AMP4 pin connector

Special cut away socket to remove 02 or Oxygen sensors from your manifold.They are usually very tight in the manifold due to various degrees of heat over a period of time.That is why this socket was invented.Makes it a lot easier to remove the sensor.It does both top and bottom sensors.